Refer to page 7 of the ENC-410 or ENC-520 Installation Instructions for position of the Mode connector. On the ENC circuit board, locate the 4-pin Mode connector and put a 2-pin jumper on the 2 outer pins.In the Com(n) Properties dialog, choose the following settings:.In the 'Connect to' dialog, use the 'Connect using' drop-down list to select the COM port you are using on your computer. Click OK.In the 'Connection Description' dialog, type a name for this session.Start HyperTerminal (Programs > Accessories > Communications > HyperTerminal).Connect the cable and adapter between the ENC’s RS-232 port and the RS-232 COM port you are using on your computer.
#HYPERTERMINAL SERIAL SERIAL#
Pinout configuration for a RJ-45 to DB-9 Null Modem Adapter (part number UNCC-405) used for serial i. also refers to these pin outs.Ĭonnection to ENC's serial system shell using Windows HyperTerminal (for operating systems without HyperTerminal, please refer to Hyperterminal on Microsoft Windows Operating Systems Refer to the Installations Instructions for ENC-410 (pages 10 & 11) or ENC-520 (pages 10 & 11) for details on the cable and adapter. A 2-pin jumper for connection to the ENC's 'Mode' connector.A functioning COM port on your computer.
RJ-45 to DB-9 adapter (part number: UNCC-405) or a socket-to-plug type RJ-45 to DB-25 adapter (part number: UNCC-430).8-conductor flat silver satin stranded cable with standard male (plug) RJ-45 connectors.Hardware required for connection to ENC's RS-232 port:
There maybe a need to access the ENC via its serial port if the IP address of the ENC is unknown or for troubleshooting purposes when the ENC's Ethernet port is not functioning.
#HYPERTERMINAL SERIAL SERIES#
0 kommentar(er)
